ReadMe.txt for the NXP (Freescale) K66FN2M0 start project.

This project was built for SEGGER Embedded Studio V6.34a.

Supported hardware:
===================
The sample project for the K66FN2M0 is prepared to run on
a SEGGER emPower board. Using different target hardware
may require modifications.

Configurations:
===============
- Debug:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS debug and profiling library
  is used.
  To use SEGGER SystemView with this configuration, configure
  SystemViewer for MK66FN2M0XXX18 as target device and SWD at
  2000 kHz as target interface.

- Release:
  This configuration is prepared for download into internal
  Flash using J-Link. An embOS release library is used.

Ozone:
======
Additionally to the project, this BSP contains an Ozone *.jdebug
project which can be used to debug and trace the debug configuration
output of the Embedded Studio project.

The Ozone project was built for and tested with Ozone V3.20e.

Note:
=====
Please make sure your device is unlocked before downloading
your application. To do so follow these steps:
- Connect your device with the J-Link
- Open the J-Link Commander
- Type: "unlock Kinetis"
Now the Kinetis device is unlocked and you are able to
download your application.
