NXP FRDM-MCXN947T

From SEGGER Knowledge Base
Jump to navigation Jump to search

This article describes specifics for the NXP FRDM-MCXN947T evaluation board.

File:VENDOR BOARDNAME.jpg

Preparing for J-Link

  • Connect the J-Link to J23.
  • Power the board via J17.
  • Verify the connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the NXP FRDM-MCXN947T.
It is a simple Hello World sample linked to run from internal flash.

SETUP