RX Adapter Rev9

From SEGGER Knowledge Base
Jump to navigation Jump to search
RX Adapter Rev9

The SEGGER RX Adapter Rev9 supports JTAG and FINE connections and replaces the RX FINE Adapter. It connects SEGGER J-Link debug probes and Flashers to Renesas RX target hardware, adapting the standard 20-pin SEGGER connector to the 14-pin RX target connector.

The following sections describe the required jumper settings and the resulting signal routing and pinouts.

For other hardware revisions, see RX Adapter. For an overview of SEGGER adapters, refer to Adapter Overview.

Target Interface JTAG

Jumper

For JTAG, set both jumpers A and B to pins 1–2, as shown below.

JTAG: both jumpers A and B on pins 1–2.

Pinout

The following pinout applies when both jumpers are set to JTAG. Jumper A routes the probe's RTCK / MD0 signal to target-connector pin 7 (MD0). Jumper B pulls target-connector pin 4 (EMLE) HIGH through a 1 kΩ pull-up to VTref.

Target Interface FINE

Jumper

For FINE, set both jumpers A and B to pins 2–3, as shown below.

FINE: both jumpers A and B on pins 2–3.

Pinout

The following pinout applies when both jumpers are set to FINE. Jumper A routes the probe's TMS signal to target-connector pin 7 (FINED). Jumper B connects target-connector pin 4 to GND.

FINED is an open-drain signal. The adapter includes a 3.3 kΩ pull-up to VTref (R9) on the TMS signal routed to FINED in FINE mode. No additional pull-up on the target board is required for this signal.

Power Supply

Jumper C (JP3) controls the optional target supply at target-connector pin 8 (VTref). Its setting is independent of jumpers A and B and applies to both JTAG and FINE.

Jumper C (JP3) Function
Pins 1–2 closed Supply the target with 5 V from the probe / programmer supply
Pins 2–3 closed Supply the target with 3.3 V through the adapter's voltage regulator
Open (no jumper fitted) Do not supply power to the target through the adapter

Select a supply voltage that matches the target hardware. For an externally powered target, leave jumper C open and connect the target's I/O voltage to VTref.

Functional Block Diagram

The following diagram shows the target-supply selection and signal routing for both target interfaces.