SemiDrive E3650 DevKit A02

From SEGGER Knowledge Base
Jump to navigation Jump to search

This article describes specifics for the SemiDrive SemiDrive E3650 DevKit A02 evaluation board.

Preparing for J-Link

  • Connect the J-Link to the 20 Pin Debug Connector (J401)
  • Power the board via J201 (12V)
  • Verify the connection with e.g. J-Link Commander. The output should look as follows:

Example Project

The following example project was created with the SEGGER Embedded Studio project wizard and runs out-of-the-box on the SemiDrive SemiDrive E3650 DevKit A02.
It is a simple Hello World sample linked to run from internal flash.

SETUP